期刊： MATERIALS TRANSACTIONS, 2021; 62 (6)
The classification of the microstructures of Al-Si-Mg casting alloy in different cooling rates was accomplished by using our originally developed meth......
期刊： MATERIALS TRANSACTIONS, 2021; 62 (7)
Cu-doped amorphous calcium phosphate (ACP) coatings were fabricated on the surface of pure titanium (Ti) by electrochemical deposition at initial elec......
期刊： MATERIALS TRANSACTIONS, 2021; 62 (8)
Disappearing of benthic seaweeds in coastal areas has gradually become a serious environmental problem worldwide. One possible reason is iron deficien......
期刊： MATERIALS TRANSACTIONS, 2021; 62 (8)
In this paper, cold-rolled DP590 dual-phase steel sheets with 1.5mm thickness were weld-bonded by a fiber laser. In order to study the tensile shear s......
期刊： MATERIALS TRANSACTIONS, 2021; 62 (9)
Electromagnetic pulse welding is a new promising method for solid-state joining of dissimilar materials. However, little understanding of the dynamic ......
期刊： MATERIALS TRANSACTIONS, 2021; 62 (9)
In the present study, a Mn-Cu-based damping alloy with a nominal composition of Mn-25Cu-2Al was produced by ball milling and spark plasma sintering. T......
期刊： MATERIALS TRANSACTIONS, 2021; 62 (8)
Wire + Arc Additive Manufacturing (WAAM) is an advanced manufacturing technology by inexpensive Gas Tungsten Arc Welding (GTAW) technology. Key micros......
期刊： MATERIALS TRANSACTIONS, 2021; 62 (9)
A wear test set-up is designed and employed to investigate the damage behavior and failure mechanisms of cemented carbide against Si 3 N 4 ceramic und......
期刊： MATERIALS TRANSACTIONS, 2021; 62 (7)
In order to reveal the variation trend of stress in T9A complex helical structure during long period of service, the stress relaxation of T9A helical ......
期刊： MATERIALS TRANSACTIONS, 2021; 62 (6)
Cu-Al2O3 composite coatings were prepared in the use of pulse jet electrodeposition technology. Pulse current parameters including duty cycle and freq......
期刊： MATERIALS TRANSACTIONS, 2021; 62 (6)
This study systematically investigated the effect of aging temperature on microstructure, impact toughness and pitting behavior of flux-cored arc weld......
期刊： MATERIALS TRANSACTIONS, 2021; 62 (7)
Twin-electrode GTAW is a novel welding technology in recent years and attracts lots of attention to researchers. However, stainless steel cladding wit......
期刊： MATERIALS TRANSACTIONS, 2021; 62 (5)
Al100-xSix (x = 2, 4, 6, 8, 10) amorphous alloy models are constructed by using molecular dynamics (MD) simulations. In order to investigate the local......
期刊： MATERIALS TRANSACTIONS, 2021; 62 (8)
Fluxless arc brazing technique using Zn15%Al filler wire with the aid of an additional milling procedure was developed to join aluminum alloy to low-c......
期刊： MATERIALS TRANSACTIONS, 2021; 62 (5)
The phase component, microstructure and compressive properties of a novel high entropy alloy, Al0.5CuFeNiV in as-cast and annealed conditions were inv......
